i have a samsung plasma tv model; ps42b430p2w that was making a clicking sound and not powering on. what can i do You can examine the capacitors in your LCD TV or monitor and actually see if they are bad. I think most of the time this happens it goes unfixed unless you have a good in-circuit capacitor tester tool. Yep, I've seen it, and it was only by the way the symptoms seemed typical to that kind of problem and dumb luck that we tried wiring another in parallel to the suspected one that we discovered it. I have a Capacitor/ESR meter. - Vizio Television. Samsung has set up a Web site to deal with the proposed settlement of a class action lawsuit applying to certain older TVs plagued by a faulty capacitor. A capacitors job is to block dc, allow ac currents to … I've looked at the circuit boards and can't seem to tell if any capacitors have gone bad. If you provide us with more details about what model your TV is as well as what the symptoms are, we might find more information for you. capacitors can also look fine and fail also . Obviously the circuit was designed for approximately the full value, so it isn’t going to work correctly at 1/10 the capacitance. The bad capacitors have a much lower capacitance than their specified value. If they appear bulged on top, then they need to be replaced. after replacing the board LJ41-06613A. Fault Symptoms Arising from Bad, Leaking or Blown Capacitors The diagnosis for any faulty apparatus will be different in each case. so i change the bad that i assume was bad . The primary cause of LCD TV and monitor failure *may*be faulty capacitors. A quick check of the fuse should be the first step, but if the fuse is good, then the problem lies elsewhere. Well, their electrolyte dried up and leaked, so what do you expect? all capacitors are good not physical damage. How can I check to see which one is bad? the \Tv is turning on now no clicking sound, but it stays blank no pictures.